Intel ISP1100 - Manual (Page 34)

34 Intel ISP1100 Internet Server Product Guide
Removing the Hard Drive(s)
This procedure describes how to remove the hard drives from the server drive bays. Before
proceeding, be sure you are thoroughly familiar with the information in “Before You Begin” at the
front of this chapter. Refer to Figure 14 while performing this procedure.
1. Disconnect the power and data cables (A) from the back of the drive.
2. Grasp the back of the drive and lift until the drive mounting bracket (B) releases from the two
snaptop standoffs (C).
3. Slide the mounting bracket back to release the tabs from the slots (D) in the server front panel.
4. Remove the mounting bracket and drive from the drive bay.
5. Use a Phillips screwdriver and remove the four screws (E) that attach the mounting bracket to
the drive (two on each side).
6. Lift the drive from the mounting bracket.
A
B
D
C
E
OMO9453
Figure 14. Removing the Hard Drive(s)