Intel ISP1100 - Manual (Page 30)

30 Intel ISP1100 Internet Server Product Guide
Installing the Processor Chip
Perform this procedure to install the processor chip in the socket. Refer to Figure 10 while
performing this procedure.
1. Grasp the end of the zero-insertion-force (ZIF) arm (A) and bend it out slightly until it
disengages from the socket tab (B).
2. Swing the ZIF arm up until it stops in the straight up position. The processor socket is now
unlocked.
3. Face the front of the server and orient the processor chip (C) with the notch (D) in the upper left
corner of the processor socket (E).
4. Gently place the processor chip on the socket so that the processor pins (F) mate exactly with
the corresponding socket pins (G). Do not force the processor into the socket since it takes
only a slight pressure to bend the pins.
5. With the processor in place, swing the arm (A) down until it snaps into the socket tab (B). The
processor is now properly socketed.
A
C
E
D
F
G
B
OMO9431
Figure 10. Installing the Processor Chip