Intel ISP1100 - Manual (Page 40)

40 Intel ISP1100 Internet Server Product Guide
Removing the PCI Add-in Card(s)
This procedure describes how to remove the PCI add-in card(s) from the server board. Before
proceeding, be sure you are thoroughly familiar with the information in “Before You Begin” at the
front of this chapter.
Removing the Filler Panel Retention Bracket
Perform this procedure to remove the filler panel retention bracket from the server back panel.
Refer to Figure 20 while performing this procedure.
1. Use a Phillips screwdriver and remove the two screws (A) securing the filler panel retention
bracket (B) to the top edge of the server back panel.
2. Remove the retention bracket.
A
B
OMO9458
Figure 20. Removing the Filler Panel Retention Bracket