Intel GA-N680SLI-DQ6 - Manual (Page 95)

Appendix - 95 -
English
Step 3:
When Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 20
below will appear. Use the ARROW keys to select one of the items displayed depending on the
operating system to be installed. For example, select GIGABYTE GBB363 RAID Controller (Windows
2K/XP/2003)
(Note) if you wish to install Windows XP (32-Bit). Then press ENTER.
Figure 20
Figure 21
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA driver again from the motherboard driver CD.
Step 4:
When the next screen (Figure 21) appears, press ENTER to continue the SATA driver installation from
the floppy disk.
Windows Setup
ENTER=Select F3=Exit
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
GIGABYTE GBB363 RAID Controller (Windows 2K/XP/2003)
GIGABYTE GBB363 AHCI Controller (Windows 2K/XP/2003)
GIGABYTE GBB360 RAID Controller (Windows 2K/XP/2003)
GIGABYTE GBB360 AHCI Controller (Windows 2K/XP/2003)
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup will load support for the following mass storage device(s):
GIGABYTE GBB363 RAID Controller (Windows 2K/XP/2003)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
(Note) If you set the Onboard SATA-II Ctrl1 Mode or Onboard SATA-II Ctrl2 Mode item in BIOS
Setup to AHCI mode, please select GIGABYTE GBB363 AHCI Controller (Windows 2K/
XP/ 2003).