Integra DTR-7.1 - Manual (Page 53)

53
Of course the DTR-7.1 can also be used to record an input source
media. This allows you to make copies of the music or videos you
like, copy them from one type of media to another, or even record
what is being broadcast on television or radio. Be aware that the
Rec Out and Zone 2 buttons use the same circuit so that you cannot
make recording and output to the remote zone (Zone 2) at the same
time.
To record the input source signal you are
currently watching or listening to
This method outputs to the audio and video outputs the currently
selected input source signal. This method allows you to a signal
while you are actually listening to or watching it.
1. Select the input source to record by pressing
the corresponding input source button.
The input source is now selected and you may watch or listen
to it as desired.
2. Press the Rec Out button repeatedly until “Rec
Sel:SOURCE” appears in the front display.
The currently selected input source signal to the TAPE OUT,
VIDEO 1 OUT, VIDEO 2 OUT outputs for recording.
3. Start recording at the recording component as
Recording a source
Notes:
• If you change the input source during recording, you will
record the signals from the newly selected input source.
• You cannot record the surround effects.
• Digital signals input to the DIGITAL INPUT (COAXIAL) and
DIGITAL INPUT (OPTICAL) inputs will be output to the
DIGITAL OUTPUT (OPTICAL) output.
• Digital input signals are only output to the digital outputs and
analog input signals are only output from the analog outputs.
There is no conversion from digital to analog or vice versa.
When connecting CD players and other digital components, do
not connect only the digital terminals, but the analog ones as
well.
• There are some restrictions on recording digital signals. When
making digital recordings, consult the instruction manual that
came with your digital recording equipment (e.g., MD
recorder or DAT deck) to know what restrictions are imposed.
• You cannot record the source connected to the MULTI
CHANNEL INPUT connector.
desired.
To confirm the settings, press the Rec Out button. The current
settings will appear for 3 seconds in the front display.
Smart Scan Controller
Push To Enter
DSP/Preset
Standby/On
Standby Zone 2
Rec Out Zone 2
Phones
Master Volume
Video 1 VCR 1 Video 2 Video 3 Tape FM AM Phono CD DVD
Dimmer Down Up Tuning
Stereo Display
Listening Mode
/DTS
Surround
On O f f
Power
FM Mute/ Mode Character/ Memory Bass/ Treble Zone 2 Vol CH Level
Exit Direct THX Menu
Video 4 / Video Cam Input
S Video Video L Audio R - -
VCR 2 Video 4 Audio Selector
Rec Out
Input source buttons