Invacare 220 - Manual (Page 47)

SECTION 12—SCOOTER ACCESSORIES
Part No. 1125053 47 220
SECTION 12—SCOOTER
ACCESSORIES
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
NOTE: The crutch/cane holder, safety flag, rear mounted basket and oxygen holder all install into
the accessory tube; ONLY one (1) of these may be installed at a time.
Installing/Removing the Crutch/Cane Holder
ƽ WARNING
The installation of the crutch/cane holder onto the back of the scooter seat signifi-
cantly increases the length of the scooter. When turning the scooter or swiveling
the scooter seat, it is important to take note of this increased length - otherwise,
injury and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.1.
Installing
1. Install the crutch/cane holder into the accessory tube located on the back of the seat.
2. Install the mounting knob to secure the crutch/cane holder in place. Securely tighten.
3. Align the slot on the base with the hook on the crutch/cane holder and slide base down
into position.
Removing
1. Remove the crutch/cane holder from the accessory tube.
2. Remove the mounting knob that secures the crutch/cane holder in place.
3. Remove the crutch/cane holder from the accessory tube.