Removing/installing the battery box, Removing, Installing – Invacare 220 User Manual
Page 41: Atteries. refer to, Refer to removing, Refer to removing/installing the battery, Refer to removing/installing the battery box
SECTION 10—BATTERIES
41
The 220 powered scooter is designed to use
two (2) 12 volt, 12 Amp-hour (12AH)
batteries.
NOTE: Recommended battery type is spill
proof and requires no maintenance except
routine charging.
NOTE: Charge batteries daily. DO NOT allow
batteries to completely discharge.
NOTE: Invacare recommends that both
batteries be replaced if one (1) battery is
defective.
FIGURE 10.1 Recommended Battery Type
Removing/Installing the Battery Box
NOTE: For this procedure, refer to FIGURE 10.2.
Removing
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to Removing/Installing the Deluxe Seat on page 31 or
Removing/Installing/Adjusting the Padded Seat on page 29.
3. Hold the battery box handle and lift the battery box up and away from the scooter.
Installing
1. Turn power off and remove the key
from the ignition.
2. Remove the seat. Refer to Removing/
Installing the Deluxe Seat on page 31 or
Removing/Installing/Adjusting the
3. Holding the battery box handle,
carefully lower the battery box on to the
battery tray in the scooter.
4. Press down the battery box to engage
the connector on the battery box with
the connector on the scooter base.
5. Reinstall the seat. Refer to Removing/
Installing the Deluxe Seat on page 31 or
Removing/Installing/Adjusting the
FIGURE 10.2 Removing/Installing the
12 Volt, 12 Amp-
Hour (12 AH)
Battery
Battery Box
Battery Box
Handle
Battery
Tray
Connector on Battery
Box
(Hidden from View)
Connector
on Base