IBM A40 TYPE 6840 - Manual (Page 8)

If NO, continue to 002 .
If YES, proceed to 003 .
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 7)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (}) or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003 .
003
Run diagnostics. If necessary, refer to “Diagnostics” on page 8.
v If you receive an error, replace the part that diagnostics calls out or go to
″Symptom-to-FRU Index″ on page 37.
v If the test stops and you cannot continue, replace the last device tested.
2 Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer