IBM 100/10 - Manual (Page 31)

21 Chapter 2 Installation
S1 is an 8 segment DIP switch for DSTN/TFT panel type and resolution
functions.
2.20 TV-out interface (optional) (CN1)
The PCM-9575 board provides optional TV-out via CN1. This consists of
a 5-pin wafer box header. Output supports composite video and S-video
connectors via an optional cable kit (p/n: 1103050306). TV-out genera-
tors use both NTSC and PAL formats.
To set up your video interface:
1.
Run the appropriate installation program located on the utility disk.
That’s all there is to it.
Table 2.4: S1 Panel Type select
SW
1-1 SW
1-2 SW
1-3 SW
1-4
Panel Type & Resolution
ON ON ON ON TFT 640x480** 18bit (H. V. Freq)
ON ON ON OFF TFT 648x480 18bit (Synthetic)
ON ON OFF ON TFT 648x480** N/A
ON ON OFF OFF TFT 648x480** LVDS
ON OFF ON ON DSTN 648x480** 18bit
ON OFF ON OFF TFT 800x600** 18bit (H. V. Freq)
ON OFF OFF ON TFT 800x600* 18bit (Synthetic)
ON OFF OFF OFF TFT 800x600 LVDS
OFF ON ON ON TFT 800x600** N/A
OFF ON ON OFF DSTN 800x600** 18bit
OFF ON OFF ON TFT 1024x768** 36bit (H. V. Freq)
OFF ON OFF OFF TFT 1024x768 36bit (Synthetic)
OFF OFF ON ON TFT 1024x768** LVDS
OFF OFF ON OFF TFT 1024x768** N/A
OFF OFF OFF ON DSTN 1024x768** 18bit
OFF OFF OFF OFF DSTN 1024x768** 24bit
* Default setting
** will support in the future