Intel ESM-2850 2047285001R - Manual (Page 64)

ESM-2850
64 ESM-2850 User’s Manual
3.5.10 Set Supervisor / User Password
You can set either supervisor or user password, or both of them.
Supervisor Password: able to enter/change the options of setup menus.
User Password: able to enter but no right to change the options of setup menus.
Type the password, up to eight characters in length, and press . The password
typed now will clear any previously entered password from CMOS memory. You will be
asked to confirm the password. Type the password again and press . You may also
press to abort the selection and not enter a password. To disable a password, just
press when you are prompted to enter the password. A message will confirm the
password will be disabled. Once the password is disabled, the system will boot and you can
enter Setup freely.