IMC Networks iMcV-Giga-FiberLinX-II - Manual (Page 48)

44
• To restore the unit to factory default settings, use the cleandb function via
the serial port (refer to the Device-Specific Options from the Command
Line section for more information). This is especially helpful if you feel you
have configured the module improperly. If restarting to factory defaults is
necessary, IMC Networks recommends using this function on both units in
Host/Remote applications, and then reconfiguring all settings.
• Ensure READ/WRITE Community Strings for iMcV-Giga-FiberLinX-II and
iView² are the same.