IMC Networks iMcV-Giga-FiberLinX-II - Manual (Page 23)

19
7. The download progress displays and ends with a successful download message or
with an error message.
8. Press Q or F4 to return to the Device-Specific Options screen.
When the iMcV-Giga-FiberLinX-II is installed in a managed chassis, you have the
option of using UMA to update the firmware (refer to the iView
2 online help for more
information on using UMA with iConfig, iMediaChassis and iMcV-Giga-FiberLinX-II).
Port Configuration—port
The iMcV-Giga-FiberLinX-II allows you to view port status and configure some port
features from a serial connection or a Telnet session. In the Commands List, type
port, and then press Enter to access the Port Status/Control screen.
In the Port Status Values area of this screen you can view the link status, link lost
counter, duplex status, and port speed.
------------------------- Port Status Values --------------------
Optics Data EXT Mgmt
--------
wn Link Status Up Up Do
Link Lost Cntr 0 0 0
Duplex Status Full Full Half
rt Speed 1000 Mbits 1000 Mbits 1000 Mbits Po
------- ------------------------- Port Control Settings --------------------
Data EXT Mgmt
bled Port Enable Enabled Ena
Admin Status Up Up
Port Speed Ctrl Autoneg. Autoneg.
l Advertise Ctrl Advert All Advert Al
Advertise FlowC Adv Flow Adv Flow
Flow Auto Flow Auto Force FlowCtrl Frc FlowCt
it FlowControl Ena. FlowC Un
ge Value. Use Arrow Keys To Move Cursor. Press Space Bar To Chan
Press RETURN To Set New Value. Press Q Or F4 To Exit
Copper SFP settings in the Optics column may be different. In the Port Control
Settings area of the Port screen you can set the following:
Port Enable–Allows you to enable or disable the port. Both Port Enable and Admin
Status must be enabled (enabled and up) to enable the port. This setting can be
disabled from iView
2 .
Admin Status–Allows you to enable (Up) or disable (Down) the port. Both Port
Enable and Admin Status must be enabled (enabled and up) to enable the port. This
setting can be disabled from MIB-II compatible software.
Port Speed Ctrl–Allows you to set the port for autonegotiation or to force one of the
following speeds:
• 10/100/1000 Mbps Half-Duplex
• 10/100/1000 Mbps Full-Duplex