IMC Networks iMcV-Giga-FiberLinX-II - Manual (Page 21)

17
(U) - Deleting All SNMP Community Strings
To delete all community strings and start over, press U. You will then be prompted,
“Are you sure you want to delete all community strings?” Press Y to proceed, N to
abort. Press Enter to finish.
This function will delete all community strings. If you want to be able to selectively
delete community strings, use iConfig to configure your device.
(E) - Ending Your Session
Ensure you press E to end the session before disconnecting the serial cable. This will
stop the continuous stream of data that is sent to the serial port.
(REBOOT) – Reboot Device
By typing REBOOT, the device will restart, which will result in a temporary loss of
operation of the unit while it re-initializes.
(D) – Enabling DHCP
By pressing D, a screen displays allowing you to enable or disable DHCP for the
device. By default, the DHCP client is disabled.
(Space Bar)—Commands List
The iMcV-Giga-FiberLinX-II also includes several device-specific options. To access
these options, press the space bar from the Main Configuration screen, type the
command name of the action you want to perform (as shown below) and press Enter.
Command Description See Page
cleandb Allows Reboot of the unit with a clean database. 18
download Downloads firmware from Server IP address using
TFTP. 18
Command Description
-------- -----------
ean Database cleandb Reboot With Cl
download File Download
ifstats Display Port Statistics
istics rmstats Display Port RMON Stat
e Version version Show Firmwar
reboot Reboot Unit
ttings security Configure Non-Standard Network Se
t Settings port Display And Change Por
config Set mode of operation
word Accounts accounts Add or Delete Username/Pass
sysdescr Change System Descriptions
unit Display And Change Unit Settings
dwidth Settings bw Display And Change Ban
pstats Display SFP DDMI Info sf
->
Press
RETURN To Go Back To Main Screen.