IMC Networks iMcV-Giga-FiberLinX-II - Manual (Page 36)

32
Transparent with Tagged Management
Transparent with Tagged Management mode passes both tagged and untagged traffic
between the DATA port and the OPTICS (or UPLINK) port. By using a VLAN Tag you
can isolate and route the management path in the module. This method can be used
with or without continuing the management path down the EXT MGMT port.
To configure this mode, do the following:
1. Set the management DIP switch ON for the ports using management (in this
example it is the OPTICS (or UPLINK) 3 = ON and EXT MGMT 1 = ON).
2. Set Transparent Mode to allow both tagged and untagged traffic to pass:
a. In the Main Configuration screen, press the space bar and type config. The
Configuration screen displays:
Transparent Mode – with either (not both) Data and Optics Mgmt DIP switches
set to on, all traffic passes between Optics and Data port EXCEPT what has
been defined as the Management Domain. The Management Domain can either be
efined as untagged traffic or traffic with a specified VLAN ID. d
In Transparent Mode with BOTH Optics and Data Mgmt dipswitches set to off,
ll traffic passes between the Optics and Data Ports. a
efault Mode – the unit passes only Untagged Packets. D
he unit is currently in Default Mode . T
Enter Y for Transparent Mode, N for no Transparent Mode or to
move to other options [ Y ]
b. Enter Y in the Transparent Mode field and press any key (except S or Q) to
open the Transparent Mode Setup screen.
Transparent Mode – with either (not both) Data and Optics Mgmt DIP switches
set to on, all traffic passes between Optics and Data port EXCEPT what has
been defined as the Management Domain. The Management Domain can either be
efined as untagged traffic or traffic with a specified VLAN ID. d
efault Mode – the unit passes only Untagged Packets. D
he unit is currently in Default Mode . T
Enter Y for Transparent Mode, N for no Transparent Mode or to move to
ther options [Y] o
The mode has changed, a reboot is necessary after all changes have been
completed. Enter S or F3 to exit with saving, Q or F4 to exit without saving.
ou may press any other key to proceed to the VLAN screen. Y
********* *******************************************************************
, Note: If the units are configured in a Host/Remote configuration
nt is an option. Standalone units do support enabling Transpare
Transparent mode.
*****************************************************************************
c. Enter Y in the Is a VLAN tag required on Management packets?
field. The screen displays the management tag fields:
Is a VLAN tag required on Management packets? [ Y ]
The Management Tag is [0 ]
Management Priority is [0 ]