Philips Magnavox MDV630R - Manual (Page 70)

68
5 Confirm with OK .
aThe following message appears on the screen: 'Please enter
channel number'
b The channel number of the TV channel has not yet been assigned
Guide. Using C , D or the number buttons 0..9 on the remote
control, select the corresponding Guide channel number (name) of
the TV channel and confirm with OK .
aThe following message appears on the screen: 'PlusCode
number wrong'
b The entered PlusCode number is incorrect. Correct your entry or
cancel using the SYSTEM-MENU button.
b Check the time/date (see chapter 'Initial installation', section 'Setting
the time and date').
aThe following message appears on the screen: 'Date does not
match Mon-Fri'
b A daily recording was entered for the wrong day. Daily programming
can only be used for recordings to be made from Monday to Friday.
Problem
Timer
VCR Plus+ system
Date
01/22 Ch.
001 Start
08:30AM End
10:00PM
Rec
Mode
HQ
To store
Press OK
6 The data appears after confirmation. You can go back to change
the data. Select the field with
C or D . Change the information
with A , B or the number buttons 0..9 .
Changing recording mode in the ' Rec Mode' input field
Select the 'Rec Mode' input field using C . Using B , A select the
recording mode 'HQ, SP+, EP, EP+'.
Tip
7 If all information is correct, press the OK button. The
programming information is stored in a TIMER block.
8 To end, press TIMER .
9 Insert a recordable disc in the Recorder.
10 Switch off the Recorder with STANDBY m .
The programmed recording will only function properly when the
DVD
recorder has been switched off using the
STANDBY m button.
If any of the TIMER blocks are in use and the recordings are set ot occur, ' s' will light up on
the display.
Programming a recording (TIMER)