Philips Magnavox DVD KITCHEN RADIO WITHTFT DISPLAY MDR700 - Manual

DVD Kitchen Radio with MDR700
TFT Display
Quick Start Guide
Preparation
Connect it
Mount it
Use it
This Guide shows you:
• basic installation setup
• how to install your unit
• how to play a DVD
• how you can watch TV on
the unit
For detailed operation of all the features, please also read the
User manual.
4
3
2
1
What’s in the box
POWER SUBTITLE AUDIO EJECT
DVD
TV
AV
1 2 3
4 5 6
7 8 9
+10 0 FM/AM
TV/LCD SETUP DVD SETUP
GOTO
INFO
SET OK
CH-
CH+
VOL +
-
TIME
REPEAT A-B SLOW
ZOOM
RC 518B
SEEK
16:9/4:3
MENU TITLE
+ -
LCD
ON/OFF LCD
ON/OFF
MUTE
CR 20 25 LIT HIUM
DVD Kitchen Radio with MDR700 TFT Display
Quick Start Guide
Preparation
Connect it
Mount it
Use it
This Guide shows you:
• basic installation setup
• how to install your unit
• how to play a DVD
• how you can watch TV on
the unit
For detailed operation of all the features, please also read the
User manual.
4
3
2
1
FM ANT INPUT VIDEO IN AUDIO IN
Mount it
Ask a friend to help out. An extra hand to hold the unit makes mounting easier
and quicker. A
• Cut the template to fit inside the cabinet.
• Align the template border marked "FRONT"
along the front edge of your cabinet. • Use adhesive tape to fix the template.
• Drill 1/4 inch holes, as marked X on the tem- plate. • Remove the template when you finish drilling.
B
Using the spacers
On the spacers, there are 4 pairs of notch length
options. Depending on the thickness of you cabi-
net bottom (with/ without an overhang), these
notch lengths correspond to the 4 notch height in
the space holders, and allow you to adjust to the
best height to help you mount the unit. • Measure the height of the cabinet bottom and/overhang. • Turn the spacer counterclockwise to determine which of the 4 heights is most suitable: Low •
• High. Align to the arrow indication. • Insert the spacers accordingly.
C
• Manually fasten the 4 screws down into the spacer holder holes to mount your
set. Start screwing at opposite corners of
the unit for better support.
Tip To prevent damage to your set, do not use an electric drill to secure screws when mounting!
– If the overhang is more than 1 1/4 inch, use longer screws (not included).
Template A
Spacer L (Low) L••H (4 heights) Arrow B
C Mounting
Screw
Tip
– Clean the bottom of the cabinet surface and also empty your cabinet before mounting. – Place the unit in a clean, safe place when drilling to avoid wood shavings dropping into the ventilation slots. – Use a nail to start each drill hole.
– Drill from the bottom upwards if you do not have enough room inside the cabinet. – Hold your drill firmly at 90o with the cabinet bottom and drill holes at low speed. – Clear wood shavings.
FRONT
1
S M A R T . V E R Y S M A R T . User guide
DVD Kitchen Radio
with TFT Display MDR700
Need help? Call us!
Magnavox representatives are ready to help you with
any questions about your new product. We can guide
you through Connections, First-time Setup, or any of
the Features.We want you to start enjoying your
new product right away!
CALL US BEFORE YOU CONSIDER
RETURNING THE PRODUCT!
1-800-705-2000
or Visit us on the web at www.magnavox.com
DVD Kitchen Radio
with TFT Display
Remote control
with one CR2025
lithium battery
16 x spacers
Quick start guide Mounting
template
User manual
12 x screws 12V DC adaptor AM antenna
FM antenna AV cable
What else you'll need
These tools (not included) will help you mount the unit as described in part 3 Mount it, and on the
template.
Preparation
For best performance, install the unit as far as
possible from sources of noise and interference
(e.g. fridges, microwaves, fluorescent lamps)
a Find a mounting location near a wall outlet.
b Use the mounting template to test the design and
thickness of your kitchen cabinet bottom.
c Decide whether you want to connect the unit with
other AV signal sources. ( See B below)
Connect it
A
Connect the following supplied acces-
sories to the respective jacks on the rear
of the unit:
• 12V DC power adaptor
• For radio reception, connect the
AM and FM antennas.
B
Other connections (cables not included)
• For TV reception on the unit, con-
nect a VHF/UHF cable.
• For use with other AV signal
sources, connect the composite cable and match
the colors of the cinches (Audio L/R, Video
in) on the unit.
2
Electric drill Tape measure Scissors
Sellotape Screwdriver Safety goggles
Printed in China JS/JW-0502
W
1
a
Template
b
To reduce the risk of fire,
do not place any heating or
cooking apparatus beneath
this unit.
2
VIDEO (Yellow)
AUDIO-R (Red)
AUDIO-L (White)
FM AM DC
75ohm coaxial
cable
MDR700 QUG-Eng 2/14/05 11:16 Page 1