Mocomtech CDM-570 - Manual (Page 264)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Serial Remote Control MN/CDM570L.IOM
13–30
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
BUC Software
Version N/A 2 bytes Query only. CDM-570L Only
Indicates the BUC software version, in the form xx,
Example: BSV=05 (Software version 05)
If not available, response is 00
Note: This command is only valid when the FSK and BUC power
are turned On.
N/A BSV? BSV=xx
(see description of
arguments)
BUC Current N/A 4 bytes Query only. CDM-570L Only
Indicates the value of the BUC Current, in the form: xxxx, where
xxxx is between 0 and 9999, units mA.
If not available, response is 0000.
Example: BDC=3100
N/A BDC? BDC=xxxx
(see description of
arguments)
BUC Voltage N/A 4 bytes Query only. CDM-570L Only
Indicates the value of the BUC Voltage, in the form: xx.x, where
xx.x is between 0 and 64.0
If not available, response is 00.0.
Example: BDV=43.6 (BUC DC voltage is 43.6 volts)
N/A BDV? BDV=xx.x
(see description of
arguments)
Terminal Tx
Frequency N/A 10 bytes Query only. CDM-570L Only
Terminal Tx Frequency, where frequency = BUC LO
± TFQ
Resolution=100 Hz
Returns 00000.0000 if LNB LO is zero
Example: TTF=14250.9872
N/A TTF? TTF=xxxxx.xxxx
(see description of
arguments)
Terminal Rx
Frequency N/A 10 bytes Query only. CDM-570L Only
Terminal Rx Frequency, where frequency = LNB LO
± RFQ
Resolution=100 Hz
Returns 00000.0000 if LNB LO is zero
Example: TRF=11650.2249
N/A TRF? TRF=xxxxx.xxxx
(see description of
arguments)