Mocomtech CDM-570 - Manual (Page 102)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Introduction MN/CDM570L.IOM
1–4
The following table shows what other options are available:
Option Description and Comments
Option
Installation
Method
Low Rate Variable Data rate 2.4 kbps to 512 kbps BASE UNIT
Mid-Rate Variable Data rate 2.4 kbps to 2.048 Mbps FAST
Full Rate Variable Data rate 2.4 kbps to 5.0 Mbps FAST
Extended Rate Variable Data rate 2.4 kbps to 9.98 Mbps FAST
8-PSK/8-QAM Modulation Type FAST
16-QAM Modulation Type FAST
RS Codec Closed-network Reed-Solomon Codec Hardware
TPC Codec 5 Mbps Turbo Product Codec (IESS-315 compliant) Hardware
TPC/LDPC Codec * Combo TPC and LDPC (Low-density parity check) Codec Hardware
100W BPSU 100 Watt, 24 volt BUC PSU (CDM-570L only) Hardware
150W BPSU 150 Watt, 48 volt BUC PSU (CDM-570L only) Hardware
IP MODULE Ethernet Interface and IP Options
IP MODULE Ethernet
interface 10/100 BaseT Ethernet interface Hardware
3xDES Data Encryption Uses NIST certified 3x core
Software Version 1.4.0 and later FAST
IP Header Compression Software Version 1.4.0 and later FAST
Payload Compression Software Version 1.4.0 and later FAST
Quality of Service (QoS) Software Version 1.4.0 and later FAST
* consult factory for availability
1.3.1 FAST Accessible Options
Comtech EF Data’s FAST system allows immediate implementation of different options
through the user interface keypad, or via the remote control interface. All FAST options
are available through the basic platform unit.
1.3.2 FAST System Theory
FAST is an enhancement feature available in Comtech EF Data products, enabling on-
location upgrade of the operating feature set without removing a modem from the setup.
When service requirements change, the operator can upgrade the topology of the modem
to meet those requirements within minutes after confirmation by Comtech EF Data. This
accelerated upgrade can be accomplished because of FAST’s extensive use of
programmable logic devices incorporated into Comtech EF Data’s products. A unique
access code enables configuration of the available hardware. The access code can be
purchased at any time from Comtech EF Data. Once obtained, the access code is loaded
into the unit through the front panel keyboard or the rear remote port.