Motorola DTR510 - Manual (Page 57)

Chapter 6 Troubleshooting
Symptom Try This:
Display shows "User Not
Available" when PTT pressed Target radio is in a call, try again after 30 seconds to determine if call has been
completed. Target radio is out of range. At least one radio (Private or Group call)
must be turned on and within range to transmit.
Display shows "Feature Not
Supported" when PTT
pressed or feature initiated.
The target radio is a DTR410 and does not support Private calls or data
features like SMS and Alert.
No Power Recharge or replace Li-Ion battery.
Message not transmitted Make sure Push to Talk is completely pressed while transmitting.
Recharge or replace battery. Verify that radio is programmed correctly.
Cannot receive Private calls Verify that the radio is on your home channel and that the radio is not a
DTR410 .
Cannot receive Public Group Make sure that the PublicGroup has the same Channel and PublicGroup ID.
Cannot access Remote Monitor,
Time or Remote Disable
(DTR610 only) Make sure that Manager Mode has been enabled in Programming.
Time Update not received Private ID of the transmitting radio must be in the Contact List of a receiving radio
to accept a Time / Date update.
DTR410 does not support this feature.
Limited talk range Steel and/or concrete structures, heavy foliage, buildings, or vehicles decrease
range. Check for clear line of sight to improve range.
Message not received Confirm radios have been properly programmed.
Recharge or replace battery.
Poor audio quality Radios are too close together. They must be at least 5 feet apart.
Radios are too far apart or obstacles are interfering with transmission.
Low batteries Recharge or replace batteries. Extreme operating temperatures affect battery life.
Serial Clone failed Make sure clone cable is properly connected.
Display shows "Please Try
Again" when PTT pressed The radio is busy. Try calling again.
Cannot see any Private contacts
in the Contact List Check to see if the Private contact is set to Group Only. A Private contact that is set
to Group Only will not see Private contacts in the Contact List.
DTR410 radios do
not have Private calling so Private contacts cannot be added to the contact
list.