Motorola DTR510 - Manual (Page 44)

April 27, 2005 6881097C81-O
4-2 Radio Programming: Entering Programming Mode
Although factory programmed with default PublicGroups, DTR Series radios require user-specific
programming in order to fully benefit from their digital features.
This occurs in a separate programming mode which allows access to modify and add contacts,
update existing and add new quick notes, and access manager features (DTR610 only) such as
Remote Disable and Remote Monitoring. A mini keyboard (53967) is used to enter text into contacts
and to modify saved text messages.
The 53968 Cloning Cable allows easier programming as one radio can be programmed with all
contact information then duplicated in other radios. The DTR510 and DTR610 also have an over-the-
air cloning feature to send a contact to another radio.
New radios should be cloned using serial cloning. After this occurs, the unit ID can be sent to the
other radios via over-the-air or serial cloning.
Entering Programming Mode
The following key sequence must be performed to enter the programming mode.
1. Hold down and press the PTT button three times.
2. Press the Right .
3. Press .
4. Press the Left .
5. Hold down and press the PTT button three times.
The Program Menu screen appears.
My Info
1. Highlight Contacts and press under Select. A appears to the right of the display.
2. Scroll to select it and press under View. Your unit name, ID, and channel are shown.
3. Press under Edit to change the unit name or channel.
Changing your unit name will change how it appears on your idle display, but Unit ID instead of Unit
Name is transmitted to other radios. A receiving radio will show your unit name if your unit ID is in it's
contact list.
Select
Program Menu
Contacts
Text Messages
Settings
Reset