Meyer Sound 616 - Manual (Page 50)

CHAPTER 4: USING THE GALILEO FRONT PANEL
50
■ Array Group: Can be used to assign an output channel to an Array Group. The default is
“none”; turning the Blue knob clockwise will scroll through “Array 1” through “Array 8”,
and assign the output to the array. The user will still need to go to the Array Correction
page to select the type and size of the array and to enable it.
■ Atmospheric Bypass: Press the Enter button or press/turn the Blue knob to toggle
between Bypassed and Enabled.
■ Atmospheric Distance: Turn the Blue knob clockwise to increase the distance, and coun-
terclockwise to decrease. Press and hold the knob for a more coarse adjustment, and to
increase faster.
NOTE: Atmospheric controls must be set for each desired output channel. Even
when channels are linked, atmospheric changes are not applied across the
group.
TIP: When viewing both EQ and phase on the graph, choose shading for the EQ
so that it is easier to distinguish between the two presented lines. The EQ curve is
shaded, and phase is not.
THE EQUALIZATION MENU
Within the TruShaping, Parametric, or High/Low Pass pages, a menu bar can be opened that
gives access to more equalization and view options and controls. When any of these pages
are displayed, press the Up arrow to open the menu at the top of the page. Pressing the Down
arrow once this menu appears will open the submenus.
At this point, using the Left and Right arrows will scroll across the main menu headings, and
the Up and Down arrows will scroll among the submenu items, highlighting them. Press the
Enter button to select the desired item.
NOTE: The Up arrow that opens the menu bar acts as a toggle; clicking it again
will close the menu bar; when the drop-down submenu is open, press the Cancel
button to escape from it.
The available items in the Equalization menu (accessed from the EQ pages) are Mode, Set-
tings, Edit, View, and Input/Output.