Meyer Sound 616 User Manual

Page 18

CHAPTER 2: GALILEO 616 FEATURES AND FUNCTIONS

NOTE:

Select whether each of these connectors will operate in the analog or the

AES two-channel digital mode on the System Settings page from the Galileo 616

front panel or the Compass software. This selection may be made individually for each
of these three connectors.

■

Analog Input Connectors: The lower three XLR-3F input connectors, labeled B, D, and F,
accept standard line-level audio only. These connectors are paired with the Analog/AES
connectors A, C, and E — typically used for the second analog channel of a left/right two-
channel signal. When one of the upper connectors is set to AES mode, the connector
below it is disabled and will not accept an audio signal. For example, if Inputs A and C are
set for AES mode, then Inputs B and D are disabled. In this example, inputs E and F may
still be used with analog signals

■

Output Connectors: These sixteen XLR-3M connectors connect to Meyer Sound self-
powered loudspeakers, or to power amplifier channels driving passive loudspeaker sys-
tems. The signal routing and processing internal to the Galileo 616 is applied to the output
of these connectors.

■

SIM 3 Bus Connectors: This pair of connectors provides connection to the SIM 3 audio
analyzer as well as loop-through to additional Galileo 616’s or SIM-3088 line switchers,
when Galileo’s connections are being used as measurement points. These connectors are
labeled “Connect to SIM 3022 or 3088 only.”