Meyer Sound 616 - Manual (Page 44)

CHAPTER 4: USING THE GALILEO FRONT PANEL
44
NOTE: Only one Snapshot at a time may be selected as the boot configuration
for Galileo, and it may be selected either in the Compass control software or via
the “Is Boot” field above. That Snapshot will have “(boot)” in front of its name in the
Snapshot Library list.
■ Recall: Highlight the Recall command using the Up and Down arrows (the Left and Right
arrows will go across the two columns of commands when the highlight cursor is in the
lower section of the Edit page), and press the Enter button to load the selected Snapshot
as the current Galileo configuration. The currently active Snapshot is designated with an
asterisk before its ID number in the Snapshot Library.
■ Update: Highlight as in Recall above, and press the Enter button to add changes to an
existing Snapshot. This command allows changes to the currently active Snapshot, rather
than creating a new Snapshot.
■ Duplicate: Highlight, and press the Enter button to create a duplicate of the selected
Snapshot. It will be placed at the end of the Snapshot Library list, and will have “#2” added
at the end of its name (the actual number will increase depending on how many duplica-
tions are made). Select it for further editing and renaming, if desired.
■ Delete: Highlight, and press the Enter button to delete the selected Snapshot. It will be
deleted from the memory of Galileo and from the Snapshot Library in a connected com-
puter running the Compass control software.