Meyer Sound 616 - Manual (Page 16)

CHAPTER 2: GALILEO 616 FEATURES AND FUNCTIONS
16
■ Settings Knobs: Three rotary encoders (with push switches) are used to change parame-
ter values for the various settings available on the Galileo, based on what is currently
selected on the LCD screen. For example, when setting Parametric EQ points, the Blue
knob adjusts the center frequency, the Green knob adjusts the bandwidth (Q), and the Red
knob adjusts the cut/boost level.
■ Ethernet LED: When this LED is lit, it indicates that the Galileo 616 is connected to the
Compass control software running on an external computer via the rear panel RJ-45 con-
nector. Remote control of the Galileo 616 is accomplished with this connection.
■ SIM 3 LED: When this LED is flashing, it indicates the Galileo 616 is communicating with a
SIM-3022 audio analyzer on its line switcher bus, either directly or daisy-chained from a
SIM-3088 line-level switcher.
NOTE: The SIM 3 Address for the Galileo 616 must be set to a number between
10 and 14, either in the System Settings menu onboard Galileo or in the Com-
pass software. It will then be available in the Switcher section of SIM 3 under tabs 10
through 14, and can be configured to perform audio measurements.
■ Power Switch / LED: Pressing this switch turns on the Galileo 616; press and hold the
switch for approximately two seconds to turn off.