Multi-Tech Systems MULTIVOIP MVP-410ST/810ST - Manual (Page 50)

Quick Start Instructions MultiVOIP User Guide
50
Phone/IP Details Often Needed/Wanted
Obtain Email Address for VOIP (for email call log reporting)
required if log reports of
VOIP call traffic
are to be sent by email
Optional
SMTP Parameters
Preparation Task:
Ask Mail Server
administrator to set up
email account (with
password) for the
MultiVOIP unit itself.
Be sure to give a unique
identifier to each
individual MultiVOIP
unit.
Get the IP address of the
mail server computer, as
well.
To: I.T. Department
re: email account for VOIP
[email protected]
Identify Remote VOIP Site to Call
When you’re done installing the MultiVOIP, you’ll want to confirm that
it is configured and operating properly. To do so, it’s good to have
another voip that you can call for testing purposes. You’ll want to
confirm end-to-end connectivity. You’ll need IP and telephone
information about that remote site.
If this is the very first voip in the system, you’ll want to coordinate the
installation of this MultiVOIP with an installation of another unit at a
remote site.
Identify VOIP Protocol to be Used
Will you use H.323, SIP, or SPP? Each has advantages and
disadvantages. Although it is possible to mix protocols in a single
VOIP system, it is highly desirable to use the same VOIP protocol for
all VOIP units in the system. SPP is a non-standard protocol developed
by Multi-Tech. SPP is not compatible with the “Proprietary” protocol
used in Multi-Tech’s earlier generation of voip gateways.