Matsushita CF-74ECBAXBM - Manual (Page 38)

9-16
9.2.9. Setting the PC Card Ejector and Lithium Battery
1. Attach the Lithium Battery to the Main PCB.
2. Pass the Lead Wire of the Lithium Battery through the
groove of the Main PCB, and connect it to the Connector
(CN14) on the back side.
3. Fix the PC Card Ejector to the Main PCB using the two
Screws.
Screws : DFHE5025XA
Q Arranging the Lithium Battery
9.2.10. Setting the Main PCB
Note:
After replacing the Main Board, rewrite the BIOS ID.
1. Set the MP Guide to the Main PCB.
2. Set the Main PCB to the computer.
3. Fix the Main PCB using the six Screws.
4. Connect the ten Cables to the corresponding Connecters
(CN6, CN7, CN24, CN19, CN28, CN21, CN802, CN18,
CN15, CN25).
Screws : DFHE5025XA
PC Card Ejector
Lithium Battery
(to CN14)
CN14
Main PCB
Pass the Cable through the groove of the Main PCB.
Safety Working
Tape
Main PCB
Lithium Battery
Match the end of the Tape.
(0 to 1 mm)
Match the end of the Tape.
(0 to 1 mm)
Connect to the Connector (CN14) on the back side.
Fix the Cable using the Tape.
Pass the Cable between the parts.
(Avoid running over the parts.)
CN6
CN7
CN24
CN19
CN28
CN21
CN802
CN18
CN15
CN26
Main PCB
MP Guide