Minicom Advanced Systems 5UM20114 - Manual (Page 40)

SMART CAT5 SWITCH 16 IP
.
39
Modem Server IP address – This address is used only when connecting to Smart
16 IP via a modem. When you dial into the Smart 16 IP the client computer will
receive a Modem Client IP address from the Smart 16 IP. Open the Web browser
and type Modem server IP address to login to the Smart 16 IP.
The Client IP (see paragraph below) must be in the same class C subnet as the
server IP. This subnet should not conflict with the Ethernet subnet on the client
side and with the Ethernet subnet on Smart 16 IP Network side.
Modem Client IP address - This address is assigned to your console computer
during the PPP handshake. Since it is a point-to-point IP connection virtually
every IP address is possible but ensure, it is not interfering with the IP settings of
Smart 16 IP and your console computer. The default value will work in most
cases.
IPMI over Serial - Check to use this serial port for IPMI 1.5 over serial. See
page 47 for more information.
Passthrough access to serial port via Telnet - Connect an arbitrary device to the
serial port and access it (assuming it provides terminal support) via telnet. Select
the appropriate options for the serial port and use the Telnet Console (see page
42) or a standard telnet client to connect to Smart 16 IP. For more information,
see page 19.
External Power Option – When the External Power Option is the Sentry
Power Tower or Baytec RPC series connected to Serial port 1, configure it by
clicking change external power switch option. The External Power Option for
Serial port 1 window appears.
Fill in the Username and password as defined by the Sentry Power Tower.
Figure 27 External Power Option for Serial port 1