MTD 769-01558 - Manual (Page 12)

2SHUDWLQJ LQVWUXFWLRQV 0RWRU +RHV English
9
8VSYFPIWLSSXMRK EMH
(ERKIV SJ MRNYV] JVSQ
MREHZIVXIRX WXEVXMRK
&IJSVI EPP [SVO SR XLMW QEGLMRI
r 7[MXGL SJJ XLI IRKMRI
r ;EMX YRXMP EPP QSZMRK TEVXW EVI WXMPP
ERH XLI IRKMRI GSSP HS[R
r 6IQSZI XLI WTEVO TPYK XIVQMREP
'EYXMSR
3JXIR QEPJYRGXMSRW MR XLI STIVEXMSR
SJ XLI QEGLMRI LEZI WMQTPI GEYWIW
[LMGL ]SY GER VIQIH] ]SYVWIPJ -J MR
ER] HSYFX SV MJ I\TVIWWP] MRWXVYGXIH
XS HS WS WIIO EHZMGI JVSQ E
WTIGMEPMWX [SVOWLST
3RP] TIVQMX VITEMVW XS FI QEHI F]
E WTIGMEPMWX [SVOWLST ERH YWMRK
SVMKMREP WTEVI TEVXW
.
!
*EYPX 4SWWMFPI GEYWI 6IQIH]
Engine does not start Fuel tank empty. Fill up fuel tank.
Stale fuel. Drain off stale fuel into a suitable vessel in
the open air
). Fill tank with clean, fresh
and lead-free fuel.
Engine in cold state, choke lever not
set at “CHOKE”. Set choke lever to “CHOKE”.
Throttle not at “START” or set to
maximum speed. Set throttle at “START” – maximum
speed.
Spark plug terminal not attached. Attach spark plug terminal to spark plug.
Spark plug contaminated or
defective. Clean spark plug ).
Have defective spark plug replaced ).
Carburettor flooded. Set choke lever to “RUN” and start.
Primer not actuated for cold start. Press primer.
Engine runs irregularly (stutters) Choke lever set at “CHOKE”. Set choke lever to “RUN”.
Spark plug terminal loosely
attached. Firmly attach spark plug terminal.
Stale fuel.
Water or dirt in the fuel system. Drain off stale fuel into a suitable vessel in
the open air
).
Fill tank with clean, fresh and lead-free
fuel.
Fuel tank cap vent blocked. Clean venting cap.
Air filter contaminated. Clean air filter ).
Machine does not hoe Earth clods prevent rotation of the
hoeing assembly. Stop engine and remove spark plug
terminal. Clean hoeing assembly.
Bolts or screws have become loose. Replace bolt or screw. Secure bolt with
spring connector.
Clutch cable badly adjusted. Have the clutch cable adjusted ).
V-belt loose or torn. Have the V-belt replaced ).
Excessive vibration Hoeing assembly loose or bent. Stop engine immediately and remove spark
plug terminal. Replace damaged parts.
Bolts or screws have become loose. Stop engine immediately and remove
spark plug terminal. Tighten screws or
replace bolts.
) See “Engine instructions”
) This work can only be executed by a specialist workshop