MITSUBISHI ELECTRIC MIM-G01 User Manual
Page 57
AT+T Mode - Activating Modem Mode or Message Mode
AT+T Help - Showing a Command Overview
AT+T Erase - Resetting the Modem
AT+T Redial
Appendix
AT Commands MIM-A01
Mitsubishi Industrial Modem
8 - 23
AT+T Mode="Mode"
Sets the operating mode of the modem.
ModemMode:
The modem works like a “normal” modem.
The standard Hayes AT commands are applicable.
The Message Mode commands are not applicable.
The red Modem Mode LED lights up.
MessageMode:
The automatic functions of the Tixi AT Modem are activated and
effective.This mode must be activated,
otherwise the message commands described here may not be
used!
The standard Hayes AT commands are not applicable.
The Modem Mode LED is switched off.
Mode:
ModemMode
(default)
MessageMode
Example:
AT+T Mode="MessageMode"
activates Message Mode.
Modem reply: OK (the Modem Mode LED turns off)
Use also:
AT+T Mode?
shows the current mode
and AT+T Mode=?
shows the possible modes
AT+T Help
Gives an overview of the instruction set of the Mitsubishi Super Modem.
In this way you can access the most important information at any time when working with the Tixi
modem even when the manual is not available
AT+T Erase
Use this command to reset the modem. The modem is reset, all user-defined settings are deleted
and the device returns to its factory default settings.
AT+T Redial
Sets the number of automatic redial attempts.
Redials
0...9
(default=0)
Example:
AT+T Redial="3"
Modem reply: OK
AT+T Redial?
Displays the configured number of automatic redials.
AT+T Redial?
Modem reply:
+T Redial:"3"
OK