Mercedes-Benz 2004 G 500 - Manual (Page 200)

200
Controls in detail
Useful features
Step 3:
̈ Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp
1 in view.
Step 4:
̈ Using both hands, simultaneously
press the hand-held transmitter
button
5 and the desired integrated
signal transmitter button ( 2, 3
or 4). Do not release the buttons until
completing step 5.
The indicator lamp 1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
Step 5:
̈ When the indicator lamp 1 flashes
rapidly, release both buttons.
Step 6:
̈ Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp
1.
If the indicator lamp 1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.
Step 7:
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
Rolling code programming
To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
Step 8:
̈ Locate “training” button on the garage
door opener motor head unit.
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.
i
If the indicator lamp 1 blinks rapidly
for about two seconds and then turns
to a constant light, continue with pro-
gramming steps 8 through 12 as your
garage door opener may be equipped
with the “rolling code” feature.
୴୴