Minolta Color PageWorks 0990-7701-02 - Manual (Page 24)

11
CHAPTER 1
In
stallation
3. Setting-Up
8
- Check that the expansion memory is mounted
securely.
7
5
- Insert the controller board into the guide rails.
- Secure the controller board in position with the
four screws.
- Take the Expansion Memory out of its carton.
- Check which type of Controller board is installed
in your printer.
- Mount the expansion memory in the socket
(SIMM3 or 4) at the location shown on the
controller board.
10
9
6
- Push the expansion memory down in the
direction of the arrow.
- This completes the procedure to mount the
expansion memory in the printer.
- You now change the setting for
memory> that is one of the setup items of the
printer driver on the host computer
.
For details, see the Printer Driver
Operator's Manual separately provided (that is
shipped together with the accessories that come
with this printer set).
- Reconnect the interface cable or network cable.
- Insert the expansion memory pin into the socket.
11
SIMM4
Controller board (a)
SIMM3
Left Side Right Side
Controller board (b)
SIMM3
SIMM4