Metz LCD-TV - Manual (Page 67)

67
The signal type always refers to the input
and output of the AV device.
Some AV devices may use a composite video sig-
nal (FBAS) for recording and playback operations
and an RGB signal for displaying their menus.
It is not possible to make a general statement in
this respect. The operating instructions of the AV
device concerned may provide some indication.
If you connect such an AV device with the signal
type "composite video" (FBAS) and recordings are
played back correctly, but you cannot see the
menu of the AV device, you must change the sig-
nal type in the menu "AV devices" to "RGB".
Setting the signal type
• Press the "MENU" key to open the TV menu.
• Press the yellow key to open the
menu "AV devices".
• Use the cursor control key to select the
AV device whose signal type you wish
to change and press the "OK" key.
• Press numeric key
·
, use the cursor
control key to select " Signal OUT",
and use the - + key to change the set-
ting to " RGB".
• Press the "OK" key to confirm your
selection.
• Press the "EXIT" key to close the TV menu.
Caution ! This may cause an existing con-
nection diagram to be modified. If so, you
must reconnect the AV devices accordingly.
☞
☞
25. Registering AV Devices
Setting signal types RGB
MENU
Other device 3
Other device 2
Other device 1
PC
Satellit / set top
DVD Player 2
DVD Player 1
DVD/Videorec.3
DVD/Videorec.2
DVD/Videorec.1
Signal OUT RGB Signal IN CVBS
Change with
Accept value with
OK
OK
ᕢ
OK
EXIT
Opening the menu
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
– +
F1 ➔
DataLogic
Name
Signal types
Connect
✗
✗
606 47 2014.A1 LCD-GB MK 22.06.2006 14:13 Uhr Seite 67