Metz LCD-TV - Manual (Page 47)

47
20.1 Activating the EPG
The EPG function can be activated by briefly pres-
sing the "EPG" key if an EPG programme position
has been defined in the menu (see below). If no
EPG programme position has been defined in the
menu, the following applies.
When any programme position on which EPG can
be received is selected, the following is displayed
after a short delay:
The TV set is thus asking whether you want to use
this station as the source for the EPG data.
If you press any key other than the green
key, this programme position is not used
as the source of EPG data. The message
will be displayed again on any other
programme position where the EPG
data are available.
If you press the green key for "Yes",
this programme position will be used as
the source for the EPG data. The messa-
ge will not be displayed for any other
programme positions.
If you know which programme position
provides EPG data, you can enter its number in
the TV menu with the numeric keys.
You can also overwrite an existing programme
position number or clear it with the II key.
Opening the menu
MENU
EPG
Not possible with an external receiver !
EPG settings
Display configuration 2)
Operating
Sound settings
HiFi output 2)
Init. prog.position
Function for F3
Function for F2
Function for F1
EURO sockets
DVB-C
DVB-T
Analog-TV
Country
Language
Operating
EPG Yes
EPG prog. position 13 Kabel 1
Change with
Accept value with
F1 ➔
OK
OK
ᕦ
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
Use this station as EPG station ?
Yes
Any other key closes this window.
☞
– +
606 47 2014.A1 LCD-GB MK 22.06.2006 14:13 Uhr Seite 47