Metz LCD-TV - Manual (Page 57)

57
The TV set will normally detect the colour standard
(PAL, SECAM, NTSC, NTSC44, PAL60, PAL M)
automatically.
If this automatic selection does not provide satis-
factory results (which should happen only rarely),
you can select the colour standard manually for
each programme position.
The colour standard is set in the factory to "Auto-
matic".
Setting the colour standard
• Press the "MENU" key to open the TV menu.
• Press the white key to open the sta-
tion table.
• Press the F2 key to enable editing of
the station table.
• Use the cursor control key to select the
programme position whose colour
standard you wish to change.
• Press the cursor control key ̈ to move
to the left column.
• Use the corresponding numeric key (in
the example:
²
) to select
"Colour standard".
• Use the - + key to select the desired colour stan-
dard, or to step through the available colour
standards until the picture is displayed clearly.
• Press the "OK" key to confirm your selection.
• Press the "EXIT" key to close the TV menu.
Opening the menu
22.1 Setting Stations
Colour standard for analogue stations
The number of subjects and sections depends
on the selected scope of operation. Depending
on the configuration of the TV set, the various
menu items may be displayed in a different
order and numbered differently.
0076 TF3
0075 TF2
0074 TF1
0073 TV France
0072 RTL 2
0071 RTL
0070 SAT 1
0069 Bayern 3
0068 ZDF
0067 ARD
Colour standard SECAM
: select
:go to the
settings
Sound corrections
Colour standard
Picture quality
Picture correct.
Enter logo
Station contained in EPG
Frequency/channel
OK
MENU
F2
EXIT
²
OK
F1 ➔
✗
606 47 2014.A1 LCD-GB MK 22.06.2006 14:13 Uhr Seite 57