Motorola DSR405 - Manual (Page 75)

Options
DSR405 User Guide 61
Installation Settings
Tune in Satellite Signal. This
option allows you to see the
strength of the signal your
antenna is receiving.
Set VCR Code. Some models
will allow you to automatically
control your VCR so it will
record programs. You will have
to enter the code of your VCR in
your receiver. You have two
ways to do so: you can enter it
directly, using your remote
control; or you can enter it by scanning through codes on your receiver and
selecting the right code.
Enter VCR Code. This option allows you to record the number code for your
VCR in your receiver. Look up the code in Section 3.0 of this manual, enter the
numbers via your remote control, and perform a test.
Scan for VCR Code. This option allows you to enter the code by scanning
through a list of VCRs and then choosing the one you want.
Set Remote Control Address. This option allows you to control up to four
receivers in a centralized area with one or more remote controls. Each receiver
requires a separate address. The default address is 000.
On the front panel of your receiver press the Menu button.
• Choose Options.
• Choose option 6 (Change System Settings).
• Choose option 3 (Installation Settings).
• On the Installation Settings menu, choose option 2 (Set Remote Control
Address). Now follow the instructions on the Remote Control Address screen.
• If you have four receivers, you will have to change the addresses on three of
them: they will have address of 000, 001, 002, and 003.
To program your remote control for each receiver, hold down the SAT key on the
remote control until the light flashes. Once the light begins to flash enter the
desired address (000, 001, 002, or 003).