Motorola DSR405 - Manual (Page 35)

Installation
DSR405 User Guide 21
Connecting the Satellite Dish, Receiver, and TV
Complete the following steps, and make sure that the satellite receiver is not
plugged into a power source before you connect any cables to the receiver:
• Connect the cable from the satellite dish to the satellite terminal on the satellite
receiver's back panel. connect the supplied three-wire (red, yellow, and white)
cable from the TV terminal on the satellite receiver's back panel to TV IN (or
coaxial cable to VHF IN) terminal on your TV.
• On the back panel of the satellite receiver, set the CH3 CH4 switch which is
located just above the TV terminal— to the same channel that you set on your
TV for use with your VCR.
• Turn on the TV and tune it to channel 3 or 4 to match the position of the switch
on the back panel of the satellite receiver.
• Plug the satellite receiver power cord into a standard power outlet. Wait one
minute, and then press the POWER key (green) on the left side of the satellite
receiver's front panel.
Using the Menus
You will be making various
adjustments to your receiver
using the keys on the remote
control or receiver.
If you use the keys on the
remote control to control the
menus, there are two ways to
select a menu option:
• Press the
34
keys or
the
56
keys to
highlight the option you
wish to select. Then press
the ENTER key to select it.
• If the options are numbered, simply press the number key for an option.
You may use the remote control, but if you use the keys on the front panel of the
receiver, there is only one way to select a menu option.
• Press the MENU key to first display the Menu screen. Then press the
34
keys or the
56
keys to highlight an option. Then press the ENTER
key to select the highlighted option.