Motorola DSR405 - Manual (Page 18)

1
4
Programming the Remote Control
The remote control is set at the factory to control all of the satellite receiver
functions, but to use it to operate your TV, VCR and auxiliary components as well,
you must "program" it for the brand you own. Follow these instructions to
program the remote to control your TV, VCR and auxiliary (AUX) components.
1. Turn on the connected component for programming.
2. Use the table that appears later in this section to find the brand of TV,
VCR or auxiliary component.
3. After the manufacturer’s brand name is a three-digit code number (or
several three-digit codes).
4. Press and hold the TV, VCR or AUX key on the remote control for at
least three seconds or until the light on your remote flashes.
5. If you are programming the TV or VCR key, continue with step 6. If
you are programming the AUX key, first press the SAT, TV or VCR
mode key to specify the type of device to be controlled before
proceeding with step 6.
6. When the light flashes, key in the first of the three-digit codes (listed
in the table) for your component using the number keys on the remote
control. Make sure to do this accurately and without a long delay. If
programming the AUX key for a satellite receiver use one of the
following SAT codes: 000, 001, 002, or 003.
7. If the remote control "accepts" the code, you will see several rapid
flashes of the light. If it does not flash, repeat steps 4, 5 and 6. After
the remote control accepts the code, press the POWER key on the
remote control to make sure the remote control is able to turn your
component off. This means it is functioning properly.
8. If your component does not respond to the remote control POWER
key, even though it has "accepted" the manufacturer’s code, repeat
steps 4, 5, and 6 using the second three-digit code from the table. If
this does not work, try the third code, etc., until the remote control
accepts the code and your component responds to the POWER key.
NOTE: Some cable box brands are also programmable using these instructions.
Check the table that appears later in this section for applicable cable box brands
and codes. You will press the TV key to program your cable box. Your remote can
only accept a TV or cable box code for this programming step.