Micron Technology Transport LT - Manual (Page 153)

Power Cord Requirement Appendix A - Regulatory
153
Power cord sets for use in other countries must meet the requirements of the
country where you use the computer. For more information on power cord set
requirements, contact your authorized dealer, reseller, or service provider.
General Requirements
The requirements listed below are applicable to all countries:
• The length of the power cord set must be at least 6.00 feet (1.8m) and a
maximum of 9.75 feet (3.0m).
• All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will be
used.
• The power cord set must have a minimum current capacity of 7 A and a
nominal voltage rating of 125 or 250 volts AC, as required by each
country’s power system.
• The appliance coupler must meet the mechanical configuration of an EN 60
320/IEC 320 Standard Sheet C13 connector, for mating with appliance inlet
on the computer.
TABLE 25. Country-Specific Power cord Set Requirements
Country
Accredited
Agency Applicable
Note Numbers
Australia EANSW *
Austria OVE *
Belgium CEBC *
Canada CSA * *
Denmark DEMKO *
Finland FIMKO *
France UTE *
Germany VDE *
Italy IMQ *
Japan JIS * * *
The Netherlands KEMA *
Norway NEMKO *