Microsoft ET180 - Manual (Page 30)

1 G e t t i n g t o k n o w y o u r E T 1 8 0
Peripherals tour
10
\
To connect the remote control unit with the headset to the device
1 Flip the earphone jack cap open.
2 Plug in the remote control plug to the earphone jack on the top edge of the device
( 1 ), then connect the headset plug to its connector on the remote control unit ( 2 ).
No. Icon Component
1 6-pole, 2.5 mm headset plug 1
2 Multimedia remote control unit
a Hold switch 2
b Forward button
c Previous button
d Clip
e Stop button
f Play/Pause button
g Remote volume rocker key
3 6-pole, 2.5 mm remote control plug
4 Remote Send/End button
5 Headset microphone 3
6 Earphones
1 The headset can be directly attached to the earphone jack on your device.
2 When the hold switch is on, all other headset-remote control buttons are locked.
3 When using the headset microphone during an ongoing call, the built-in device microphone is
disabled.