Milan Technology MIL-W2332G User Manual

Page 40

4. On the computer, run the TFTP Server utility. And specify the folder in which the

configuration backup file resides. A configuration backup file is named by the AP’s
MAC address. For example, if the AP’s MAC address is 00-01-02-33-44-55, the
configuration backup file should be “000102334455.hex”.

5. On the computer, run a Web browser and click the General, Firmware Tools hy-

perlink.

6. Choose

TFTP as the Firmware management protocol.

7. Within

the

Configuration Backup/Restore section, specify the IP address of the

computer, which acts as a TFTP server. If you don’t know the IP address of the
computer, open a Command Prompt, and type IpConfig, then press the Enter key.

8. Trigger the restoring process by clicking Restore. The AP will then download the

configuration backup file from the TFTP server.

NOTE:

Make sure the file is a valid configuration backup file for the AP.

TIP:

If you want to remotely back up or restore configuration from the Internet, adjust

the Timeout and Max no. of retries settings of TFTP Server for remote TFTP configu-
ration backup/restore to succeed.

3.3.3.5 Resetting

Configuration to Factory Defaults

Fig. 30. Configuration reset.

Clicking the Reset button resets the device configuration to factory defaults.

WARNING:

Think twice before clicking the Reset button. You’ll lose all your current

configuration settings.