Motorola SBV5220 - Manual (Page 31)

Introduction Installation Troubleshooting Glossary License
SBV5220 VoIP Cable Modem User Guide 22
Configuring TCP/IP
The Motorola VoIP cable modem contains all required software. You do not need to configure the Motorola VoIP
cable modem, but you must be sure that your computer is configured for
TCP/IP (a protocol for communication
between computers). Perform one of the following:
•
“Configuring TCP/IP in Windows 98, Windows 98 Second Edition, or Windows Me” on page 22
• “Configuring TCP/IP in Windows 2000” on page 25
• “Configuring TCP/IP in Windows XP” on page 28
•
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the IP address :
•
“Verifying the IP Address in Windows 98, Windows 98 Second Edition, or Windows Me” on page 32
• “Verifying the IP Address in Windows 2000 or Windows XP” on page 33
• Follow the instructions in your Macintosh or UNIX user manual
Your cable provider may provide additional instructions to set up your computer.
Configuring TCP/IP in Windows 98, Windows 98 Second Edition, or Windows Me
1 On the Windows Desktop, click Start.
2 Select Settings and then Control Panel from the pop-up menus.
3 Double-click the Network icon on the Control Panel window. The Network window is displayed:
4 Select the Configuration tab.
5 Verify that TCP/IP is installed for the adapter that will be used to connect to the Motorola VoIP cable modem
by looking for TCP/IP. If found, TCP/IP is installed. Skip to step 10. If TCP/IP is not installed for the adapter,
continue with step 6.