Motorola 68P09396A92-A - Manual (Page 17)

BASIC OPERATION
P l a c i n g a C a l l
1. With the power on, enter the number you wish to call.
2. Press Í.
3. Begin the conversation when the called party answers.
4. To terminate the call, press ´.
To Correct an Error
To clear the last digit entered, press and quickly release Ç. To
clear the entire entry, press and hold Ç until the entire entry
is erased.
If Entering More Than 10 Digits
You can call a phone number with up to 16 digits, but only the
last 10 digits will appear in the display.
When recalling a stored phone number that is longer than 10 dig-
its, the display will flash the memory location number and the last
10 digits of the number. Press ‰ again to view entire number.
Unsuccessful Call Attempts
If you hear one of the following signals, you have not successfully
completed your call.
Tone / Message Description
Cellular System Busy
fast busy Press Í again before ending the unsuccessful
(reorder signal) call attempt to automatically redial the call
SND TO
(refer to Automatic Redialing page 18), or press
REDIAL
´
and dial the call again.
Cellular System Could Not Complete the Call
alternating You may have tried to place a call before the
high/low tone NS (No Service) indicator stops flashing to let
(intercept) you know your phone was fully operative.
SND TO
Either press Í again before ending the
REDIAL
unsuccessful call attempt to automatically redial
the call (refer to Automatic Redialing page 18),
or press ´ and dial the call again.
busy signal The called party’s line is busy.
17