Maxon Telecom MODMAX MM-6280IND User Manual
Page 61
HSDPA Standard At Commands Page 61 of 61 Version 1.2
0 None
1 PAP
2 CHAP
additional parameters are required, as
follows:
0 – Neither username nor password
accepted
1 – Username and password
accepted
2 – Only password (secret)
accepted
Query command, i.e., $QCPDPP?,
does not display password values and
only displays username for PAP
authentication.
$QCPWRDN
used to power down the ME
Returns OK and then shuts down the
phone
Supported
$QCDGEN=<
cid>,length>
Generates data over
+CGACT activated PDP
context
– 21 to 2^32
Supported only during PDP context
activation by +CGACT
Supported
$QCSLOT=
set SIM card slot commands
will operate on
Slot other than 1 only available if
FEATURE_DUAL_SLOTS enabled
Supported
$QCPDPLT=<
enable>
Enable/disable tolerance to
long delays in PDP call setup
Supported
$QCPINSTAT
?
sends the ME the status of
all PINs for all cards
Statuses listed in order: SIM PIN, PH
FSIM PIN, NET PIN, NETSUB PIN,
SP PIN, CORP PIN, SIM PIN2
Supported