Maxon Telecom MODMAX MM-6280IND - Manual (Page 26)

HSDPA Standard At Commands Page 26 of 61 Version 1.2
Table 15. +CREG parameter command syntax
Command Possible response(s)
+CREG=[]
+CREG? +CREG: ,[,,]
+CME ERROR:
+CREG=? +CREG: (
list of supported s)
value
:
0 disable network registration unsolicited result code
1 enable network registration unsolicited result code +CREG:
2 enable network registration and location information unsolicited result code +CREG:
[,,]
:
0 not registered, MT is not currently searching a new operator to register to
1 registered, home network
2 not registered, but MT is currently searching a new operator to register to
3 registration denied
4 unknown
5 registered, roaming
: string type; two byte location area code in hexadecimal format (e.g. "00C3"
equals 195 in decimal)
: string type; two byte cell ID in hexadecimal format
1.20. PLMN selection +COPS
Set command forces an attempt to select and register the GSM/UMTS network operator.
is used to select whether the selection is done automatically by the MT or is forced by this
command to operator (it shall be given in format ) to a certain access
technology, indicated in . If the selected operator is not available, no other operator shall
be selected (except =4). If the selected access technology is not available, then the same
operator shall be selected in other access technology. The selected operator name format shall
apply to further read commands (+COPS?) also. =2 forces an attempt to deregister from
the network. The selected mode affects to all further network registration (e.g. after =2,
MT shall be unregistered until =0 or 1 is selected).
This command should be abortable when registration/deregistration attempt is made.
Read command returns the current mode, the currently selected operator and the current Access
Technology. If no operator is selected, , and < AcT> are omitted.