Maxon Telecom MODMAX MM-6280IND - Manual (Page 31)

HSDPA Standard At Commands Page 31 of 61 Version 1.2
Table 19. +COLP parameter command syntax
Command Possible response(s)
+COLP=[]
+COLP? +COLP: ,
+COLP=? +COLP:
(list of supported s)
value
(parameter sets/shows the result code presentation status to the TE):
0 disable
1 enable
(parameter shows the subscriber COLP service status in the network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
, , , , : refer +CLIP
1.24. Read operator names +COPN
Execute command returns the list of operator names from the MT. Each operator code
n>
that has an alphanumeric equivalent n> in the MT memory shall be
returned.
Table 20. +COPN action command syntax
Command Possible response(s)
+COPN +COPN: ,
[+COPN: ,
[...]]
+CME ERROR:
+COPN=?
value
n>
: string type; operator in numeric format (see +COPS)
n>
: string type; operator in long alphanumeric format (see +COPS)
1.25. Informative examples
1.25.1. Operator information reading
Command: AT+COPS?
Expected response: +COPS: mode, format, name
mode possible values:
0: automatic registration
1: manual registration