Maxon Telecom MODMAX MM-6280IND User Manual
Page 45
HSDPA Standard At Commands Page 45 of 61 Version 1.2
+CGQREQ=?
+CGQREQ:
of supported
(list of supported
[
supported
of supported
Value
: a numeric parameter which specifies a particular PDP context definition (see the
+CGDCONT and +CGDSCONT commands).
The following parameters are defined in 3GPP TS 23.107 [46]:
: a numeric parameter which specifies the precedence class
: a numeric parameter which specifies the delay class
: a numeric parameter which specifies the reliability class
: a numeric parameter which specifies the peak throughput class
: a numeric parameter which specifies the mean throughput class
If a value is omitted for a particular class then the value is considered to be
unspecified.
1.32.5.
Quality of Service Profile (Minimum acceptable) +CGQMIN
This command allows the TE to specify a minimum acceptable profile which is checked by the
MT against the negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification
parameter,
+CGDSCONT commands, the +CGQMIN command is effectively an extension to these commands.
The QoS profile consists of a number of parameters, each of which may be set to a separate
value.
A special form of the set command, +CGQMIN=
context number
negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, the parameter value ranges for each PDP type are returned on a separate line.
Table 32.
+ CGQMIN parameter command syntax
Command
Possible response(s)
+CGQMIN=[
[,
[,
[,
[,
[,
OK
ERROR
+CGQMIN?
+CGQMIN: