Maxon Telecom MODMAX MM-6280IND - Manual (Page 39)

HSDPA Standard At Commands Page 39 of 61 Version 1.2
+CGANS Opt.
Manual response to a network request for PDP context
activation
Not supported
+CGCLASS Opt. GPRS mobile station class Supported
+CGCLPAD
(GPRS only) Opt. Configure local triple-X PAD parameters
Not supported
+CGEREP Opt. Packet Domain event reporting Supported
+CGREG Opt. GPRS network registration status Supported
+CGSMS Opt. Select service for MO SMS messages Supported
1.32.1. Define PDP Context +CGDCONT
The set command specifies PDP context parameter values for a PDP context identified by the
(local) context identification parameter, . The number of PDP contexts that may be in a
defined state at the same time is given by the range returned by the test command.
A special form of the set command, +CGDCONT= causes the values for context number
to become undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, , the parameter value ranges for each are returned on a
separate line.
Table 28. +CGDCONT parameter command syntax
Command Possible response(s)
+CGDCONT=[
[, [,
[,
,[,
[,
[,…[,pdN]]]]]]]]]
OK
ERROR
+CGDCONT? +CGDCONT: , ,
,,, [,[,…[,pdN]]]
[+CGDCONT:,, ,,,
[,[,…[,pdN]]]
[...]]
+CGDCONT=? +CGDCONT:
(range of supported s), ,,,(list of supported
s),
(list of supported s)[,(list of supported s)[,…[,(list of
supported s)]]]
[+CGDCONT:
(range of supported s), ,,,(list of
supported s),
(list of supported s)[,(list of supported s)[,…[,(list of
supported s)]]]
[...]]
Value
: (PDP Context Identifier) a numeric parameter which specifies a particular PDP
context definition. The parameter is local to the TE-MT interface and is used in other
PDP context-related commands. The range of permitted values (minimum value = 1) is