Maxon Telecom MODMAX MM-6280IND - Manual (Page 13)

HSDPA Standard At Commands Page 13 of 61 Version 1.2
The following diagram shows the naming convention of messages between MT2 and TE2.
Figure 1. Naming convention diagram
1.8. DTE-TA/DCE interface commands
Table 3. ITU-T V.250 commands relating to TE-TA interface
Command Req Description Support
E Mand. Command echo supported
Q Mand. Result code suppression supported
S3 Mand. Command line termination character supported
S4 Mand. Response formatting character supported
S5 Mand. Command line editing character supported
V Mand. DCE response format supported
X Mand. Result code selection and call progress monitoring control supported
&C Mand. Circuit 109 DCE RLSD (DCD) behavior supported
&D Mand. Circuit 108 DTE DTR behavior supported
+IPR= Opt.
Fixed Rm Rate. This numeric extended-format parameter
specifies the data rate at which the MT2 will accept
command set, in addition to 1200 bit/s or 9600 bit/s (as
required in EIA/TIA-602). It may be used to select operation
at rates at which the MT2 is not capable of automatically
detecting the data rate being used by the TE2.
115200bps. (Default)
+IPR? Displays current set value.
+IPR=? Displays range of (supported auto detectable rates),
(list of supported fixed-only rates). e.g. +IPR: (1200, 2400,
supported
Response (excluding AT)
TE2 MT2
Command (including AT)
TE2 MT2
Notification (excluding AT)
Indication (message)
TE2 MT2
Signal (H/W)