Philips Magnavox 27MDTR10S - Manual (Page 34)

34 Zero Return (Videotapes)
The tape counter shows the elapsed recording or playback
time in hours, minutes, and seconds from the point at which
the counter was set to zero. The counter time will not
change on a blank tape or blank portions on a tape. The “–”
before the tape counter indicates the amount of remaining
recording/playing time before the counter reaches zero.
Follow the steps below to reset the tape counter to zero at
a tape location you want to refer to later.
1 Play, rewind, or fast forward the tape to the
location you would like to refer to later. Press
STOP C to stop the tape.
2 Press C.RESET to set the counter to 0:00:00.
3 To return to this same point later, press
SETUP. Press ▲ or ▼ to select ZERO
RETURN. Then, press B.
The tape counter will appear on the screen. When
the tape reaches the point at which you set the
counter to zero, the tape will stop. Press PLAY B to
watch the tape from the designated point.
– TV/VCR SETUP –
TIMER PROGRAMMING
SETTING CLOCK
CHANNEL SET UP
USER’S SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
B ZERO RETURN
TIME SEARCH
INDEX SEARCH
PLAY
STOP
ENTER
RECORD
DISC
MENU
RETURN TITLE SETUP
A-B
REPEAT SEARCH MODE CLEAR
MODE ANGLE SUBTITLE AUDIO
DISPLAY
SPEED C.RESET
POWER PICTURE SELECT SLEEP
CH.
VOL.
MUTE
ZOOM
1 2 3
4 5 6
7 8 9
0 +10
+100
REPEAT
3
3
2
1