Philips Magnavox ZV427MG9 - Manual (Page 84)

84 EN EN
VCR FUNCTIONS
One-touch Timer Recording (OTR) Index Search
This feature allows you to set the recording length simply
by pressing [REC] on the remote control.
Press [VCR] first.
1) Insert a recordable tape with an erase-protection
tab intact.
2) Select the recording mode using [REC MODE].
(Refer to “Note for DVD to VCR duplication” on page 42
and “Recording” on page 83.)
3) Press [SOURCE] to select the appropriate external
input position (L1/L2) to which your external tuner
is connected.
4) Press [REC] to begin the one-touch timer recording.
You can select a fixed recording time by pressing
[REC] repeatedly.
(0:30) (1:00)
(Normal recording)
(7:30) (8:00)
When the one-touch timer recording is finished, the
unit will turn to the standby mode automatically.
To change the recording length during the one-
touch timer recording:
Press [REC] repeatedly until the desired length appear.
To cancel the one-touch timer recording within the
specified time:
Press [STOP
C].
Note
• The remaining recording time will be displayed on the
front panel display during one-touch timer recording.
Press [DISPLAY] to see it on the TV screen.
• You cannot pause the one-touch timer recording.
• If VCR one-touch timer recording is completed during
DVD playback or recording, the VCR will be in stop
mode and the DVD keeps the current mode.
• Unlike a timer recording, you can perform the following
operations during the one-touch timer recording.
- Turning the power to the standby mode to stop one-
touch timer recording.
- Using [REC] or [STOP C] on the remote control.
• When the one-touch timer recording is finished and the
power is in the standby mode, the unit will switch to
the timer standby mode automatically if a timer
recording has been programmed. Press [TIMER SET] to
cancel the timer standby mode for using the unit
continuously.
• This function is available only when the unit is
connected by the VIDEO OUT jack.
An index mark will be assigned at the beginning of each
recording you make. You may skip to a specific marked
point by following the steps below.
Press [VCR] first.
1) Press [SEARCH] so that “INDEX SEARCH” menu
appears.
2) Using [the Number buttons], enter the number of
recordings you wish to skip within 30 seconds.
INDEX SEARCH
03
3) Press [ E], [D] to start index search.
If you want to go in the forward direction, press [ D].
If you want to go in the reverse direction, press [ E].
After index search, the VCR will play back the cassette
tape automatically.
Pro.1 Pro.2 Pro.3 Pro.4 Pro.5
02 01 01 02 03
Beginning
of tape End
of tape
CURRENT PROGRAM
INDEX MARK
Note
• You can make the index mark up to 20.
• This function is available only when the unit is
connected by the VIDEO OUT jack.